BUSMASTER 3.2.2.52 adds automatic E2E protection for CAN and CAN FD transmission
BUSMASTER 3.2.2.52 (Build 586) adds automatic end-to-end (E2E) protection to the CAN and CAN FD Transmit Window. Select the algorithm and protection fields defined by the receiving ECU. BUSMASTER updates the rolling counter and computes the checksum before each transmission, for both manual and periodic sends.
Configure E2E in the Transmit Window
Section titled “Configure E2E in the Transmit Window”On a test bench, the receiving ECU can use E2E to check the counter sequence and checksum. With transmit protection enabled, BUSMASTER writes both fields to each test frame using the selected configuration.
The example below uses teaching frame 0x2A7.
-
Load E2E_CRC8.dbc and add the standard frame
E2E_CRC8_Messagein the CAN Transmit Window. -
Select CRC8-2F + RC4b under Dynamic Message. In the E2E pane, bind the counter to
AliveCounterand the checksum toChecksum. BUSMASTER reads each field’s start bit, width and byte order from the DBC.
-
Leave the application data at zero, set the first counter to
1and reset it. Use append display and send the frame manually four times. The last two bytes in the four Rx records are01 45,02 34,03 1Band04 D6.

During periodic transmission, users can switch algorithms, edit available parameters or reset the counter. The CFX project can store the transmit settings.
Built-in algorithms and DLL extensions
Section titled “Built-in algorithms and DLL extensions”Seven E2E algorithms are available directly in the Transmit Window. For an OEM project, consult its communication matrix for the counter range, checksum coverage and parameters.
| Support | Algorithms and use |
|---|---|
| Built-in AUTOSAR profiles | P01, P02, P04, P05 and P06 |
| Built-in CRC8-2F + RC4b | CRC-8 with a default polynomial of 0x2F and a 4-bit rolling counter. Applicable to messages using this rule in projects from Geely and other OEMs. |
| Built-in SUM8-XOR + RC4b | Byte sum XORed with 0xFF, with a 4-bit rolling counter. Applicable to messages using this rule in projects from BYD, GAC and other OEMs. |
| Other E2E algorithms | Load a compatible DLL in the E2E Algorithm Manager to implement the project’s protection rules. |
Other improvements
Section titled “Other improvements”- With BUSMUST drivers, the CAN/LIN channel limit rises from 32 to 100 for message and signal monitoring, logging and BLF conversion.
- LIN LDFs can be removed or reimported per channel while retaining the channel’s bitrate, protocol and master/slave settings.
- Local third-generation CAN/CAN FD channels connect with a shorter wait. The release also fixes CAN connection issues when LIN is already online and connection issues with some ETAS BOA devices.
- Trace output groups repeated events and stores diagnostic information in a central location.