Skip to content
BUSMUST
中文Support

CAN Simulation in BUSMASTER

Introduction:

BUSMASTER can be used as master to transmit master requests and as slave to respond to master requests. User can monitor/analyze the LIN messages using BUSMASTER.The following steps are required to Configure the BUSMASTER for transmission of frame headers or transmission/reception of LIN messages.

1. Controller (Driver) Selection:

BUSMASTER can be connected to Physical CAN Network using CAN Controller.Refer /docs/busmaster/reference/topics/can-controller-configuration/ section for more Information.

2. Configuring CAN BUS Parameters:

Once the required driver is selected CAN BUS parameters (like baud rate, BTR0, BTR1, etc..)need to be configured. Refer CAN Channel Configuration section for more information.

3. Database Configuration:

This is an optional step and is required for Message&Signal interpretation of CAN data in BUSMASTER. Refer CAN Database Configuration section for more Information.

4. Connect to Network:

Once the Configuration done, BUSMASTER can be connected to CAN Network using CAN->Connect. menu.

5. Monitoring Messages:

BUSMASTER CAN Message Window can be used to monitor the CAN messages of CAN Network.Refer CAN /docs/busmaster/reference/topics/message-window/ section for more information.

Authoritative source: BUSMASTER DITA help source CAN_Simulation.dita, compiled into BUSMASTER.CHM with the application.